Command ID 42 - move cursor to a paragraph with a certain name

[Top]  [Chapter]  [Previous]  [Next]

You can use this command to move the cursor to a paragraph with a certain name. (Use CurrPar.ParStrCommand with id 4 to set the name)


param is a bitfield:


bit 1:

0 : Search for the name (case insensitive)

1 : Search for a paragraph which contains the text.


bit 2: (=4)

0 : Position the cursor as if the user would have moved it there

1 : Position the cursor using low level assignment. This makes it possible to reach paragraphs which are not accessible otherwise.


bit 3: (=8)

0 : Return "1" if the cursor was moved, "", if not.

1 : Return the text in the found paragraph.

[command_id_42___move_cursor_to.htm]    Copyright © 2007 by WPCubed GmbH